Jump to content

Sand


Tsarmina

Recommended Posts

pros: easier to plant plants, looks nicer (in my opinion), plants grow better in it, easier for fish to move it (if necessary for breeding) but i guess not in ur guppy tank :)

cons: small, may get sucked up in vac, but i doubt it

if it were up to me i'd say go sand, but hey it's your tank

Link to comment
Share on other sites

I use quite corse sand in most of my tanks (Collect it either from the Hutt River or down on the South Coast - but you can get good stuff at Wainui Beach too) If you get it from the coast you need to wash it well to get all of the salt etc out, but make sure it doesn't contain much shell (the darker it is the less shell it contains) as shells with riase the pH - unless of course you want a higher pH which guppies would like... either way test the pH to be safe but I would highly recomend corse sand and you can even use a gravel vac on it as long as you control the flow (by partly blocking the pipe!)

Good luck...

Link to comment
Share on other sites

If you get it from the coast you need to wash it well to get all of the salt etc out, but make sure it doesn't contain much shell (the darker it is the less shell it contains) as shells with riase the pH

i don't think i have ever seen a shell on the wainui beach :D:P

thanks for the advice.

Link to comment
Share on other sites

also if you have it really thick it can get dead spots as there very little water flow/oxygen getting down there to the bacteria, easy to combat though- heavily plant so the roots break everything up or run ya fingers/fork through it each water change. looks great IMO and with a few stones mixed in here and there and a few larger rocks looks really natural

Link to comment
Share on other sites

id take the fish out, small sand particles could irritate gills. depending on how well you washed it first anywhere from a couple of hours to a few days but cloudyness can be nailed with water changes :D i got my sand (very dark grey) from benchmark, its plasterers sand and its had no effect at all on my water or my axies (only have it in axolotl tank right now).

deep as you want in, mines a couple of cm at most but i like to make little mountains cause it looks more natural. i think there would be specific depths for plants though so look into that if you want it planted.

Link to comment
Share on other sites

It can try your patience but I buy river sand from the local nursery and put it through a kitchen seive. Carefully wash the fine gravel you collect and place the unwashed fine stuff and micronutrients in the tank with the washed fine gravel over the top to hold the silt down. I have only done this in a new setup as it would make an existing tank very murky. Minimum depth about 50mm

Link to comment
Share on other sites

I know its been mentioned on here in another thread but I ( and some others on here) use "Daltons Propogating Sand" .

I have currently got a small 2ft goldfish tank set up with it as the substrate. The GF's seem to be doing OK as are the plants.

I washed all the small stuff out using a kitchen seive as Alan suggests, only difference being that I didnt keep any of the finer particles. I supose you could always add some nutrient base under the sand if you want better plant growth. Check out Freshwests comments about increasing top layer thickness to stop leaching.

And at about $10 for a 20 odd kg bag I dont think i would ever use anything else. Looks good too.

Link to comment
Share on other sites

I think we all use underwater filters....

Just kidding. Sand is bad for undergravel filters. Falls through the holes and clogs up the works.

Sorry, I think I'm not being clear enough.

I'm not using an undergravel filter, I'm using one of those box filters that you leave submerged underwater with an air pump pumping air into it. Think that will be fine with sand? Else I did use pure gravel. I was hoping to mix some sand and gravel but whatever doesnt clog the filter will be fine.

Link to comment
Share on other sites

If you seperate the courser sand and wash it thoroughly, add the fine sand and silt along with micronutrients and put the course washed sand on top. Then put a dinner plate with a jug on top over the sand and fill the water into the jug you should not need a filter. I use a small electric sponge filter in 4ft tanks to stop temperature layering and a minimum of 50mm 0f sand (up to 200mm in one tank) with no problems. You need to plant the tank well with hungry plants and allow them to become established before loading the tank with too many fish. If you don't get the "clean/clean" bug and allow some krud to build up in the sand and filter the tank will harbour good microorganisms and start cycling for you. As the food builds so will the good bugs and also your ability to add more fish and therefore more food for your plants. Good luck

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...