Joshlikesfish Posted November 20, 2010 Report Share Posted November 20, 2010 So I took a standard 2'x1'x1' tank Added a sheet of acrylic to the middle, with around a 6mm gap from the bottom Added 3 sheets of glass to make the divided sections All I need to do is let it cure and clean the excess silicone off :lol: My handy work was terrible but I have to start somewhere. My friend ended up doing the glass parts :lol: I'm going to run a small power head up a pipe that sprays water into all four compartments. Each compartment will contain one male fighter. At the back I'll probably run a small sponge filter and a heater (till I get a fish room) The gap by the acrylic is so that the water will be taken out of the compartments and to the heater. Any suggestions on how to improve it? Quote Link to comment Share on other sites More sharing options...
dreams Posted November 20, 2010 Report Share Posted November 20, 2010 Personally I would make the compartments a bit bigger..but thats just me When you put in the spray bar, you may need some taps to control the water flow if the powerhead is too strong, otherwise, nice job Quote Link to comment Share on other sites More sharing options...
Joshlikesfish Posted November 20, 2010 Author Report Share Posted November 20, 2010 Each fish as a 14cm long section. Huge compared to the bottles they'd have been living in haha Quote Link to comment Share on other sites More sharing options...
Zayne Posted November 20, 2010 Report Share Posted November 20, 2010 very nice! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.