Fishless Cycling

[wellmax]

THIS ARTICAL IS NOT MY OWN, I HAPPENED UPON IT ON THE WORLD WIDE WEB. http://www.aquariumsecrets.com/Fishless.htm

Let’s begin with a science lesson.

No, you won’t be tested afterward, but if you are a bioscience enthusiast, that is probably what lead you to this hobby. A fish tank is like own ongoing science experiment. If you don’t know the following like the back of hand, read over and over until you do.

The Nitrogen Cycle

You remember this from fourth grade: Animal waste(feces and urine), decaying food, plants and animals, create nitrogen that passes into compounds that form ammonia. Ammonia is a highly reactive, toxic gas to animals.

Ammonia is oxidized by the “good” bacteria and turns into nitrites and then nitrates. Nitrates are used as plant food and enter the nitrogen cycle once again.

In the natural world this is going on continuously. In the tank world, you must give a helping hand to the process by doing routine water changes to reduce the ammonia, and not over feeding, which will increase the waist.

A high nitrate level will cause stress on fish and make them more susceptible to disease. The uneaten food, decaying plants and fish waste can be removed using mechanical filtration. This is why you will need a test kit to check for ammonia, nitrite, and nitrates.

The old way to re-create this cycle in an aquarium is to set everything up, add a few “disposable” fish, then wait 4-6 weeks until the “good bacteria” which convert ammonia into nitrites into nitrates have become established. It is very common at this point for the stress caused by toxic ammonia and / or nitrites to kill some or in extreme cases all of starter fish, no matter how hardy they're supposed to be. In addition, it's a well-known fact that the damage caused by high ammonia levels to the gills of a fish is, to some extent at least, permanent.

Once the tank has been fully cycled, you can start adding fish slowly, usually at a rate of a couple every week or two, until capacity is reached. This slow addition allows time for the relatively small bacteria culture on filter to grow until it can handle the increased bio-load. If done incorrectly, for example by adding too many fish at once after the cycle, an ammonia/nitrites spike can occur before the bacterial colony can adjust.

This method took an average of 4 – 6 weeks, and the fish had to be introduced slowly as opposed to putting all fish in at the same time.

Born on the Internet just a few years ago was a new, faster harmless way to cycle tank.

Fishless Cycling

If you mention fishless cycling at pet store, you'll most likely get rolling of the eyes, incredulous looks, or blank stares. They rather sell you the fish now, and then sell you an armload of medications and water preparations when fish start dying from ammonia poisoning.

Fishless Cycling is actually a tradition started on the internet, refined and popularized by Chris Cow. This technique of using store-bought ammonia is becoming quite popular, and for very good reason. The method uses store bought ammonia (plain ammonium hydroxide, if you can get it) to prime the bacterial “nitrifying” process that metabolize ammonia to harmless nitrate in aquariums.

In order to properly cycle a tank, all that's required is the filter media, water movement (to supply oxygen to the bacterial colonies), an introduction of the right type of bacteria, and a source of ammonia.

First step is to start everything up and add some few potted plants (their roots contain all of the necessary bacteria, and the plants themselves do not seem to be harmed by this process). You can also add some gravel from an established tank. Most fish store employees will provide this free. On the first day, add 4 – 5 drops of ammonia per 10 gallons (It will be more or less depending on the grade of ammonia). You should get a reading on ammonia kit of about 5 ppm. Record the amount of ammonia this took, then add that amount daily until you get a nitrite spike. Once you have nitrites, cut the ammonia back to half the previous amount per day until the nitrites disappear.

You will know that you have finished cycle when all of ammonia and nitrite levels are 0 and pH has stabilized. (This means the number is not jumping around but staying consistent). The tank should be able to cycle through the additional doses of ammonia chloride within a couple of days of addition if bacterial populations are sufficient. The whole process usually takes anywhere from 10 days to 3 weeks, depending on the fish tank

Once the tank has been cycled, the bacterial colony created by this method can handle a large fish load immediately. The amount of ammonia added to the tank during the cycle is significantly higher than what would be contributed by a small number of hardy fish, therefore, a much larger, healthier bacterial colony exists at the end of the cycle using ammonia than would if you used fish.

"Cycling" a new aquarium is easy. It's inevitable, in fact, if you'll give it time. Nitrifying bacteria are so apt to scavenge any source of nitrogen--— whether in the form of ammonia or as nitrite--— that it takes some pretty good lab technique to keep suitable cultures free of them.

Sources of ammonia. Household "ammonia" is a fairly dilute solution of ammonium hydroxide with some "quality control" agents. To avoid the perfumes, sudsing agents and dyes in consumer-type ammonia cleaning products, look for a generic brand from a hardware store. But don't hunt for a stronger solution: if you go above about 5ppm ammonia at any point, you'll only delay the completing of "cycle." . One good rule of thumb: If it doesn't list the ingredients, or say Clear Ammonia (or Pure Ammonia or 100% Ammonia, or Pure Ammonium Hydroxide), then leave it on the shelf and look elsewhere. Shake the bottle if you're not sure about it... ammonia with surfactants will foam, while good ammonia will not.

Sources of Bacteria

1) Filter material (floss, sponge, biowheel, etc.) from an established, disease free tank.

2) Live Plants (preferably potted, leave the rock wool on until cycling is finished). Crypts or Amazon swords are good choices, and not too demanding.

3) Gravel from an established, disease free tank. (Many Fish Store Employees will give this away if asked nicely)

4) Other ornaments (driftwood, rocks, etc.) from an established tank.

5) Squeezings from a filter sponge (any Fish Store should be willing to do this...)

There are also a number of commercial bacterial supplements (Cycle, Stress-Zyme, etc.) available. In this author’s opinion, these have very little to no effect, and are best left on the shelf.

Bio-Spira. There is a pet store alternative to fishless cycling called Bio-Spera. Many products claim to be “cycling bacteria” but really, Bio Spira is the only one worth anything. Its about $11-15 for enough to treat a 30 gallon tank. It can cycle tank in just a few days. You won't find it at Walmart, Petco, Petsmart or any other big chain store, only at a local shop.

Dr. Tim Hovanec and a team at Marineland Labs developed this product and put on the market in 2002, which is said to contain a founder population of Nitrospira-type bacteria to start the "cycle." In this case you add fish, but not ammonia! Cycling with Bio-Spira is not fishless cycling. fish store employee may have had some initial resistance to this product, as it needs to be kept under refrigeration. You can find out more about this interesting development, which is getting good early reviews from fishkeepers on the Internet forums, by checking the description at Marineland Labs' website.

If you start cycling with Biospera, you should be able to add the fish almost immediately. If you have already started cycing it may take more than the usual dose and longer than usual to cycle the tank. Best to add the BioSpira and wait a day. If the levels are dropping after a day wait to see if they drop further. If they are the same or higher after a day, add the rest of the packet.

Too Much Ammonia?:

It IS possible to add too much ammonia to the tank (generally several times the amounts suggested in either recipe), If you realize that you've added way too much ammonia simply do a water change, or if necessary a series of water changes to bring the ammonia and/or nitrite levels back into the readable range on test kit. Then proceed as normal with daily additions of ammonia until the tank is cycled.

Fishless Cycling - Once the tank is established

Ammonia levels can be tolerated by most fish up to 1 ppm without permanent damage. Nitrites up to 0.25 ppm. So keep it below that and you should be fine. There will be a few fluctuations at the beginning as the bacteria adjusts to meet the fishes needs but it should be fine.

Thank you for reading about Fishless Cycling

[kiwiplymouth]

Well said and a great post

[wellmax]

This artical is not mine, I happened upon it on the world wide web.

Regards John Mc

[kiwiplymouth]

Best you acknowledge the web site before the mods/admins jump on you.

It's a great informative post .

As you know through our PM's I believe that the same job can be done without store bought products. The end result is still the same.