I had a bit of fun a little while ago. I found four sheets of 85cm x 37cm x 6mm glass at a second-hand shop, cost $10 for all four! 8)
So I took them home and set myself up to chop up one sheet to make the ends and bracing for a 85x37x37 tank. I'd done some test cuts on some scrap glass and thought I had the knack of it, so I try to scour (spelling?!) the one pane. Not a scratch..
Hmmm ... tried again in a slightly different place - no luck...
Third time... pushed damn hard on the cutter and did a fairly pathetic line. :evil:
Figured "what the hell, I'll try it"
Got covered up in tough clothes and checked my work gloves then went to snap the glass. It wouldn't break! Pushed harder ... nothing. Third time ... Wow, I have 120,000 new bits of glass! :lol:
As you have probably guessed I now have three panes for good quality safety glass. :roll: So now the question is: what the hell can I go with it?!
I'm thinking a tank with 1/2/3 panes of glass on the facing side and the other sides fibreglass on ply. Any other ideas?