quack Posted November 26, 2006 Report Share Posted November 26, 2006 i just brought a new co2 setup off trade me. :bounce: is it suposed to be really had to get the bubble rate to stay the same? to adjust it, it has a tap on the side of it which you only need to turn it a fraction to adjust it and is easly to much or not enough and then itll change after a few minutes so i have to change it again :evil: is the tap ontop of the bottle ment to be opened all the way and then the side regulater to adjust the flow? Quote Link to comment Share on other sites More sharing options...
fishboi Posted November 26, 2006 Report Share Posted November 26, 2006 is the tap ontop of the bottle ment to be opened all the way and then the side regulater to adjust the flow? Yes open on top and yes side to adjust the flow. u need to get a needle valve $15 from a model hobby shop. one more post to 1000 Quote Link to comment Share on other sites More sharing options...
evilknieval69 Posted November 26, 2006 Report Share Posted November 26, 2006 one more post to 1000 Join the club mate, you know you want too!!! Quote Link to comment Share on other sites More sharing options...
quack Posted November 26, 2006 Author Report Share Posted November 26, 2006 yeah ok thought that was what i needed. thats for that! Quote Link to comment Share on other sites More sharing options...
HandS Posted November 28, 2006 Report Share Posted November 28, 2006 i have one of those (which i will be selling soon ) and i found it worked fine, they did take 5 minutes of fiddling around with to get right, but then they worked well. The biggest problem i had with mine is the bottle only lasts 1-2 months. Hope you get yours sorted soon Quote Link to comment Share on other sites More sharing options...
shiuh Posted November 28, 2006 Report Share Posted November 28, 2006 oh man..nice little toy...must be expensive! Quote Link to comment Share on other sites More sharing options...
quack Posted November 30, 2006 Author Report Share Posted November 30, 2006 HandS doyou use a needle valve? the tap on the side is way to touchy to adjust it, could it be posible that it is "worn out" i went to the only model shop in town an they didnt really have what i needed. they had one which was tiny and i would need to get reducers no make the tubing fit onto it and was $50 i was wondering if anyone has one lying around that they would sell me? or would i beable to make one? the tubing is around 1cm outside diameter. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.