20mm thread valve on 45 degree

[chimera]

I need the following pipe fitting:

It needs to be black plastic such as the hansen fittings. I have tried getting a hansen fitting like the above where the 15mm comes straight out from the thread and heating and bending it but the plastic is quite thick and wont budge! I would also consider putting an attachment on instead but it must be rigid.

[Pegasus]

What you need is the 20mm reducing bush.. or bulkhead fitting.. with the 15mm female thread.

Then get the 15mm M and F 45deg fitting which is standard to screw into it.

Both are standard at any decent plumbing supplies.

Bill.